The Power LED and Error LED will let you know the status of mPOP, for instance if it is in normal standby, if it is waiting for Bluetooth pairing to be performed, and also if an error occurs (for example if the printer is out of paper).
For normal use
Power off status.
Power on, standby status.
A USB device for which only USB charging is supported is connected to the USB port.
<Connectable USB conpatible products: BCR-POP1, SCD222U and DS9208>
When tablets and such are connected for charging, it will blink for about 5 seconds and return to the status display.
USB hub has been connected.
(USB hub cannot be used)
Will blink for about 5 seconds after the USB hub has been connected, and return to the status display.
Error display (automatic recovery error)
Error indicates it will move automatically to normal usage because the inside temperature of mPOP has decreased.
Since the printer head temperature is high, printing has stopped.
When the printer head temperature returns to a normal range, printing will resume automatically.
Since the substrate temperature is high, printing has stopped.
When the substrate temperature returns to a normal range, printing will resume automatically.
Error display (error in which recovery is not possible)
Try turning the power off, and then on. If the same error is displayed even after the power is turned on again, contact the seller.
The cutter did not operate properly.
If paper is jammed, then remove the paper, reset the paper and confirm whether the error is resolved.
If the error is not resolved, try turning the power off and then on again. If the same error is displayed even after the power is turned on again, contact the seller.
Paper Setup
Supply of power is not consistent. Or, abnormality has been detected for the power unit.
Try turning the power off, and then on. Try changing the location for the electrical outlet and turn on the power again. If the same error is displayed even after the power is turned on again, contact the seller.
An abnormality has been detected for the printer head thermistor (temperature sensor).
Try turning the power off, and then on. If the same error is displayed even after the power is turned on again, contact the seller.
An abnormality has been detected on the Bluetooth module.
Try turning the power off, and then on. If the same error is displayed even after the power is turned on again, contact the seller.
An access error has been detected for the flash.
Try turning the power off, and then on. If the same error is displayed even after the power is turned on again, contact the seller.
An access error has been detected on the EEPROM.
Try turning the power off, and then on. If the same error is displayed even after the power is turned on again, contact the seller.
An access error has been detected on the SRAM.
Try turning the power off, and then on. If the same error is displayed even after the power is turned on again, contact the seller.